Dvele Home Additions & ADU Nationwide

Dvele Home Additions & ADU: The Boca Raton Owner’s Guide

We install Dvele-compatible home additions and ADU systems in Boca Raton with flat written pricing that starts at $45,000 for a standard addition and runs to $130,000 for complex multi-room builds with full utility tie-ins. Our crews carry Dvele-compatible structural connectors, weather-sealing assemblies, and HVAC integration kits on the truck, and we can typically begin rough-in within two weeks of signed approval. Most Boca Raton owners first realize something’s wrong when they spot water staining along the addition’s seam with the main roof, feel a pronounced temperature swing between the original structure and the new space, or notice the exterior cladding pulling away after a tropical storm cycle.

Call (754) 254-8065

Which Dvele Models This Applies To

Dvele produces prefabricated panelized additions and standalone ADU units across several product lines, and the compatibility question usually comes down to which generation of connection hardware was used at the marriage wall, the point where the Dvele module meets your existing structure. Early Dvele Series 1 units, common in California-to-Florida relocations between 2019 and 2022, used a bolted steel moment frame with proprietary thermal breaks that differ in spacing from the Series 2 and Series 3 clamp-and-gasket systems now standard. The label you’re looking for is a stamped aluminum tag on the interior of the utility chase, usually near the electrical panel, reading either DV-1000, DV-2000, or DV-3000 followed by a six-digit manufacture date. If the tag is missing, measure the bolt pattern on the exterior connection flange: Series 1 runs 16 inches on center, while Series 2 and 3 moved to 24 inches to match Florida wind-load engineering.

We are an independent service provider, not affiliated with Dvele. For OEM parts, we source through Dvele’s approved distribution network, though in most Boca Raton cases we spec functionally equivalent aftermarket structural hardware from Simpson Strong-Tie or USP Connectors that carries the same Miami-Dade wind rating at a lower lead time. The aftermarket route matters here because Dvele’s California-based parts fulfillment can run six to eight weeks, and Florida’s wet season does not wait.

Signs Your Dvele Home Addition & ADU Is Failing

• Water intrusion at the marriage wall. The butyl tape and compression gasket between your Dvele module and the existing structure degrades faster in Boca Raton’s UV exposure than in cooler climates. You’ll see staining on the interior drywall first, usually within 18 to 24 months of installation if the original sealant was not rated for South Florida solar load.
• Temperature stratification between old and new spaces. The mini-split or ducted system that came with your Dvele unit was sized for the module’s envelope, not the thermal bridge created by an imperfect marriage wall connection. If your addition runs four to seven degrees off the thermostat setting, the wall’s insulation continuity has likely failed.
• Exterior cladding gaps or fastener pop. Dvele’s fiber-cement panel system expands and contracts on a different coefficient than traditional Florida stucco. Fastener heads will telegraph through or panels will shift at seams, especially on west-facing walls that take afternoon sun across Boca Raton’s long summer days.
• Musty odor from the crawl or utility chase. The Dvele module’s sealed undercarriage was designed for drier substrates. On Boca Raton’s sandy, high-water-table lots, vapor migration upward meets the cool metal pan and condenses. Mold follows within a season if the weep screed drainage was not adapted to local conditions.
• Doors or windows that bind in their frames. Dvele units ship with European-style tilt-turn hardware that tolerates minimal racking. If the module’s foundation has settled even a quarter-inch on Florida’s compressible sands, the frame geometry shifts and the multipoint locking system misaligns.

Before

After

Replacement Cost & What’s Included

The range depends on three factors we assess during our first visit: whether the existing foundation requires helical pier stabilization on sandy soil, whether the marriage wall damage has propagated into the main roofline, and whether your Dvele unit’s electrical service needs upgrading to meet current Boca Raton building code. Every quote is a flat written price with a written scope, delivered before any work starts, under Clause 1 of the Haven Standard. Our 365-Day Done Right Promise covers the labor and materials; the structural hardware itself carries a 20-year manufacturer’s defect warranty.

DIY or Call Us?

There is one safe check a homeowner can make: walk the exterior with binoculars after rain and look for cladding gaps, fastener corrosion, or flashing that has pulled free. Document what you see with photos, because that record helps us scope the repair before we arrive.

Everything else belongs to a licensed contractor. The marriage wall carries structural load; disturbing its connectors without temporary shoring risks collapse. The butyl tape and gasket system requires controlled compression that only works with the manufacturer’s torque sequence. And any work that breaks the building envelope in Boca Raton triggers a permit and inspection under Palm Beach County’s current code, which means plans, engineering, and a passed final before occupancy. We’ve rescued three DIY attempts in the past two years where the owner saved $800 in labor and spent $14,000 correcting water damage and code violations. Call (754) 254-8065 and we’ll deliver a written price before anyone picks up a tool.

FAQs